10mm, NAVIGATION / LANDING LIGHTS FOR RC AIRPLANE 


 

This kit will contain 6, High intensity LED's. 4, 10mm LED lights and 2, 5mm LED with 7mm frenzel lenses. All lights are pre-wired with 48" length wires and operate on 4.8Vdc at 250Mah.. 

The kit contains:
2, 10mm, White - 380,000 mcd (950 lumens) ea
1, 10mm, Red - 280,000 mcd (830 lumens)
1, 10mm, Green - 400,000 mcd (910 lumens)
1, 5mm, Red - flashing, 10,000 mcd (41 lumens)
1, 5mm, White - flashing, 20,000 mcd (83 lumens)
2, 7mm, clear frenzel lenses
Each LED is pre-wired with 48" length of twisted wire.
Instructions for operation and using on different voltages.

 

 

The BRIGHT lights you see in this demo are what you get in this kit. You can install them on your airplane, helicopter, boat or car.

You may have noticed that I was able to turn the lights on and off by using my transmitter. See my other auctions for the RC Servo switch.

Radio Shack sells LED lights but they are not as bright as the ones shown here in the demo. The brightness is indicated by the MCD value of each LED. Radio Shack and other Nav lights being sold are in the 7,000 MCD range, these are up to 33 times brighter and cost less than the others.

I also offer 5mm and 8mm LED Nav lights that are great for smaller planes like the Park Zone Super cub and Mini Cub, etc....

Each light set is guarantied for 90 days against defective workmanship. MADE IN USA



Larry Barnes
www.spudgun.com/led.htm